Current position: Batte > Feeder news >
    The way to solve the problem that the weightless feeder can not be loaded and started
    There are three ways to solve the problem that the weightlessness feeder can not be overloaded. First, to reduce the impact of ore on weightlessness feeder , the traditional method is to reduce the obliquity of the back wall of the silo through experiments according to the specific conditions of each unit, but this method will make the material slide slowly and have adverse effects on production, so that on the one hand it will not affect production, on the other hand it can solve the impact pro
    Analysis of failure causes of vacuum feeder
    The vacuum feeder is recommended to check the following parts when there is no suction or suction reduction. 1. Compressed air should be kept at 0.4-0.6 mpa. The insufficient supply pressure of compressed air will lead to insufficient backblowing force, which will make the dust on the surface of the filter unable to be cleaned up, thus affecting the suction speed of the vacuum feeder. 2. pipe connection must be tightened. Pipe connection should be tightened with a hoop to prevent leakage from af
    Weight loss type feeding system for key points
    s we all know, weightlessness feeding system is a conveying equipment for bulk materials. On the one hand, the weightlessness feeder can convey fine materials with particle size less than 5 mm, on the other hand, it can also convey bulk materials with side length more than 1 m. It has the advantages of continuous and uniform transportation, adjustability and strong adaptability. Therefore, it is widely used in the material processing production line of building materials, metallurgy, electric po
    Maintenance of automatic weightlessness feeder
    First, when the automatic weightlessness feeder is running, it is better not to put anything on it, which will easily lead to excessive pressure on the motor and burn it. Two, check whether the belt is intact and whether there is any loosening. Feeding machine is relying on the belt to transfer materials, only the normal belt can give full play to the production performance of the machine, the workload can reach the maximum. Because all the parts of the feeder are connected by gears and chains,
    Characteristics of vacuum feeder filter
    Vacuum feeder in the previous article has made a more comprehensive introduction to you, todays small edition focuses on the vacuum feeder filter to do the relevant introduction, I hope to help you better use it. The characteristics of vacuum feeder filter are as follows: 1, choose high-quality polyester long fiber material production. Corrosion resistance, pressure resistance, smooth surface, strong strength, small resistance, large volume of filter air. 2. The folding production technology gre
    Analysis of key points for weightless feeding system
    As we all know, weightlessness feeding system is a conveying equipment for bulk materials. On the one hand, the weightlessness feeder can convey fine materials with particle size less than 5 mm, on the other hand, it can also convey bulk materials with side length more than 1 m. It has the advantages of continuous and uniform transportation, adjustability and strong adaptability. Therefore, it is widely used in the material processing production line of building materials, metallurgy, electric p
Home 1 2 3 4 5 6 7 8 9 10 NextPage LastPage Total: 10Page59Record
©2015 Batte Mechanical Zhengzhou Co,.Ltd. All rights reserved.  sales@battemachinery.com
As a gravimetric feeder manufacturer and supplier, Batte exports gravimetric feeder products, especially gravimetric screw feeders.